Menu 7. System Menu; Alarms - BOREAL HYDROBOREAL Série Instructions D'installation, D'utilisation Et D'entretien

9.9.3.

MENU 7. SYSTEM MENU

This menu allows the access to technical menu. This access is protected by password and is only
available for our after sales service. Otherwise, non authorized person acceding this menu will
follow by a warranty lost.

10. ALARMS

In case of an anomaly during operation, the electronics of the boiler intervene and highlight the
irregularities that have taken place in the standard operation of the boiler, depending on the type
of fault.
Every alarm situation puts the boiler to be an automatic "lock out" state. By pressing
unlock it. Once the boiler has reached the appropriate cooling temperature, the user can restart it up
(Check the chapter 9.7.11.). The list of alarm codes that we can see and the description, are shown in the following table:
Alarm Code Description
Er01 Intervention of the safety thermostat, even when the boiler is turned off
Er02 Intervention of the safety air pressure switch, only when the smoke fan is working
Er03 Switching off of the boiler due to smoke temperature decrease Possible lack of fuel or blockage of it.
Er04 Turning off the boiler due to overheating of the water temperature
Er05 Switching off of the boiler due to overheating of the smoke temperature
Er07 Error Encoder: the encoder of the smoke extractor does not receive signal
Er08 Error Encoder: the adjustment of the smoke extractor speed is not possible
Er09 Low water pressure
Er10 High water pressure
Er11 Values DATE/TIME are not exact after a long power failure
Er12 Ignition of the boiler unsuccessful
Er15 Power dip
Er16 Error Display communication
Er17 Smoke extractor do not regulate due to an excess or fault of flow
Er18 Lack of fuel (pellet)
Er23 SHW accumulator probe not connected
Er25 Error of the burner cleaning base. Only mod. Hydroboreal A.
Er27 Error broken cleaning motor.
Er34 Minimum flow of the flow sensor
Er35 Excessive flow of the flow sensor
Er39 Flow sensor broken
Er41 The primary air flow is insufficient during the check of the boiler
Er42 The primary air flow is high
Er47 Auger Encoder Error: the encoder of the auger does not receive signal
Er48 Auger Encoder Error: the speed regulation of the auger is not possible
Er52 Er52 IO module error I2C
Maintenance Error: it signals that operating hours set have been reached (1200 hours). You need to call the technical
Mant
assistance.
Besides the failure codes, the stove can show the following messages that do not block its operation:
MESSAGE
Prob Anomaly on the probes control in check-up.
Service This message means that the operating hours have been reached (1200). It is necessary to call the technical assistance service.
Block Ignition This message appears when the system has not been turned off manually during the Ignition phase (after the preload): the system will
turn off when it works at full capacity.
Cleaning on Doing a periodic cleaning. Only shown in pellet mode.
Link Error Fail of communication between the card and the display
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
we can
DESCRIPTION
61
System Menu - Password
0000
HYDROBOREAL
EN