Cleaning The Burner; Boiler Switch Off; Switch On Again The Boiler; Boiler Stopped - BOREAL HYDROBOREAL Série Instructions D'installation, D'utilisation Et D'entretien
During the standard working of the boiler automatic cleaning processes are appearing periodically. The cleaning remains during a few seconds and
it consists on cleaning the rest of pellet in the burner, blowing (increasing the exhaust fan speed) and therefore help the proper function of the boiler.
EN
During this process the display will show the following message:
In the Hydroboreal 23A and 27A models, the burner has an automatic ash cleaning system, in addition to blower burner cleaning. The burner has
a cleaning system that periodically sends the ashes that are generated in the combustion to the ashtray (Cleaning system patented) which consists of
rotating the base of the burner and brush it.
9.7.8.
BOILER SWITCH OFF
To switch off the boiler we have to push the key
smoke extractor works at maximum power. This process will not finish until the boiler has reached the proper cooled temperature.
Meanwhile you will see these messages in the display:
11:24
9.7.9.
SWITCH ON AGAIN THE BOILER
Once the boiler is switch off it will not be able to switch it on again until some security time has
elapsed and the boiler is cool enough. If you try switch on the display will show the message
"Recover. Ign."
Once security time has passed the boiler will switch on again starting a new lighting cycle.
9.7.10.
BOILER STOPPED
In the next picture you will see the message the display will show when the boiler is stopped.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
11:24
Wed 11 September
Cleaning On
during three seconds. Then the boiler start the end cleaning process where the auger stop and the