Startup; Tuning Of The Remote Control And Receiver; Channelling System; Placement Of The Optional Channelling Kit - BOREAL RADIOFRÉQUENCE Série Instructions D'installation, D'utilisation Et D'entretien

6. STARTUP

The ignition of this kind of equipments is automatic, so, please do not put on the burner any kind of material to ignition.
It is forbidden to use liquid substances such as alcohol, gasoline, petroleum or similar products. The use of this
substance leads the loss of warranty.
Before the ignition, follow the next verifications:
- The electrical cable must be connected to the electrical network (230 Vac) with a socket equipped with earthing system.
- The bipolar switch, placed on the side of the stove, must be in position I.
- The pellet tank must be supplied.
-
The combustion chamber must be clean.
- The burner must be clean and properly placed.
- The combustion chamber door must be closed correctly.
During the first ignition could happen that the stove or insert has finished the ignition cycle and there is no flame. In this case the stove automatically
starts an alarm state. This happens because the fuel feeder is empty and needs a moment to fill in. To solve this problem start again the stove (taking into
account the previous considerations) until the flame appears.
The stove, at the beginning, must be subject to different start-up cycles so that all materials and the paint can complete different elastic expansions.
At the beginning, it is possible that you note smoke or smell which are typically produced when metals are subject to high temperatures or when the
paint is still fresh. This paint is boiled at 80º C for a few minutes when construction, but it must exceed for a time the temperature of 200 ºC before the
adhesion to the metallic surfaces.
Therefore, it is important to adopt these measures during the ignition phase:
1. Assure that there is a good air refill in the place where the equipment is installed.
2. During the firsts ignitions, keep a low power work and the oven lit during at least 6-10 hours continuously.
3. Repeat this operation at least 4-5 times or more, depending on the needs.
4. During the first ignitions, you should not place any object on the equipment and, in particular, on lacquered surfaces. Lacquered surfaces should
not be touched while the equipment is heated.
6.1

TUNING OF THE REMOTE CONTROL AND RECEIVER

Your equipment is provided with a remote control and a receiver. If both of them are not tuned the following message will appear l: "CERCA CAMPO"
To tune them, follow the next steps:
- You must turn off the general power supply switch of the equipment.
- Press at the same time buttons number 1 and 2 of the remote control until the screen shows "SEGLI UNITA".
- Select the radio frequency channel you prefer: 0,1,2,3,4,5,6 or 7.
- Restart the general power supply switch of the equipment.
- At the end, press red button number 3 of the remote control until both devices are connected.
- When they are tuned the screen will show the original state.
CERCA
CAMPO
MENU

7. CHANNELLING SYSTEM

The operation of the air distribution system to other adjacent or superior rooms of the model Slim 12 stove that has this system is detailed below.
The Slim 9 and Insert 7 models do not have the possibility of placing a piping system, therefore, they can only direct the flow of hot air to the room
where they are installed.
7.1

PLACEMENT OF THE OPTIONAL CHANNELLING KIT

NOTE: This operation must be performed by a professional.
For the Slim 12 model, you can purchase one or two optional channelling kits (KIT-C-D and KIT-C-I), which correspond to the ductable forced air outlets
for the adjacent or upper rooms. You can choose the outlet position of the ducts: rear outlet or top outlet, as the system allows you to choose between
both options for the right and left fan.
01
SEGLI
UNITA
MENU
EN
08:53
31.0 ºC P-1
APAGADO
MENU
33