Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Designation: Automatic spray gun
Technical data
Pressures
Max material pressure
Max. atomiser air pressure
Control air pressure
Connections:
Coating material
Control air (recommended internal dia. with a line length of 4m)
Atomiser air
(recommended internal dia. with a line length of 4 m )
Weight
Noise level (nozzle-dependent)
Max. material temperature
Max. control and atomiser air temperature
Normal spray pro-
TROUBLESHOOTING, OPERATING MALFUNCTIONS, SPRAY PROFILE
file - flat jet (only
DEFECTS
with flat jet nozz-
les)
Excessive spray profile
toward the top and bot-
tom
Spray profile veers
markedly to left or right
Heavy application in the
centre of the spray profile
Split spray profile
Surging or halting materi-
al jet
Material leakage at seal
nut
Material nozzle drips
http://www.krautzberger.com
Type: MIKRO 3
PROBLEM
Soiled air nozzle
Soiled material nozzle
Soiled air nozzle
Soiled material nozzle
Too much material
Excessively viscous material
Insufficient material
Flat jet air pressure too high
Insufficient material feed
Blocked material path
Loose or damaged material nozzle-
Worn needle gasket
Needle gasket defective
Worn or damaged needle
Soiled or damaged material nozzle
Order-No.:
0,6MPa 6(bar)
1,2MPa (12bar)
0,6-1,0MPa (6-10bar)
G1/8"a
hose 3/5mm
hose 3/5mm
ca. 320g
73-96db(A)
+70°C
+50°C
CAUSE
2830
2831
2808
ENGLISH
REMEDY
Clean nozzles
Clean nozzles
Reduce material feed
Dilute material
Increase material feed
Reduce flat jet air pressure
Increase material feed
Clean
Tighten or replace
Replace
Replace needle gasket
Replace material needle
Clean or replace material nozzle
11
Publicité
Table des Matières
