Special Equipment; Disposal; Technical Data - Krautzberger Perfekt 4 Manuel D'utilisation

CHANGING THE MATERIAL NEEDLE
LOOSEN JAM NUT (24)
UNSCREW AND REMOVE STOP SCREW (25) AND JAM
NUT (24)
REMOVE SPRING (23) AND COMPLETE NEEDLE (20, 21,
22)
LOOSEN NEEDLE PUSHER (22) AND UNSCREW NEED-
LE (20) FROM NEEDLE BOLT (21)
With nozzle sizes of 3.0 and bigger, the needle strengthener
must be unscrewed from the needle tip before changing the
needle. The needle strengthener is accessible after you have
loosened the air (2) and material nozzle (3).
ASSEMBLE IN REVERSE ORDER
NEEDLE GASKET
Remove material needle as described above
Loosen trigger screw (6)
Remove trigger shaft (5) and trigger (14)
Loosen sealing nut (10)
Remove pressure spring (11), washer (12) and seal
cone/gasket (13)
ASSEMBLE IN REVERSE ORDER
NOZZLE EXTENSIONS
Nozzle extensions are particularly suitable for the coating of
cavities such as pipes, canisters, cans or other hardtogetat ves-
sels. Nozzle extensions are available in a variety of standard
designs. They can also be tailored (length and shape) to suit
12
OPERATING INSTRUCTIONS

SPECIAL EQUIPMENT

Equipressure/Flow pressure ver-
sion for viscous media
To improve the flow characteri-
stics of viscous media, the sub-
stance is exposed to compres-
sed air in the cup.
The required compressed air is
taken from the air duct of the
spray gun. This means that the
material pressure is equivalent
to the atomiser air pressure.
WITH THIS VERSION, THE
ATOMIZER AIR PRESSURE IS
LIMITED TO MAX. 4BAR!
specific customer needs.
WHEN WORKING WITH A NOZZLE EXTENSION AND FLAM-
MABLE MATERIALS, NOTE THAT EXPLOSIVE MIXTURES
CAN BE CREATED EXTREMELY EASILY IN CAVITIES!
ALWAYS ENSURE ADEQUATE VENTILATION!

DISPOSAL

Clean the spray gun when necessary to ensure that
no hazardous substance residues remain in the
gun.Following dismantling of the spray gun, the
metal parts can be sorted and forwarded to a recy-
cling process.The nonmetal parts should be dispo-
sed of in a suitable manner.

TECHNICAL DATA

Pressures / Working temperature
Max. material pressure:
Max. material temperature (8h con-
tinuous duty ):
Max. atomizer air pressure:
Max. atomizer air pressure Equi-
pressure/Flow pressure version:
Max. atomizer air temperature:
Connections
Flow cup connection:
Material connection on handle:
Atomiser air
Weight
(without material cup)
Continuous sound pressure level
(depends on nozzle)
Angle of spray jet in front of nozzle Up to approx. 90°
Range of spray jet (depends on
nozzle and coating substance)
Document: DOK-011
0,6 MPa (6 bar)
43 °C
1,2 MPa (12 bar)
0,4 Mpa (4bar)
43 °C
W 17,5 x 19 AG
G3/8 AG
Hose NW 8/9 or
G1/4 AG
approx. 590 g
73-96 dB(A)
Up to 4m
mail@krautzberger.com