Publicité
NR-377046
EN
1. Jack up the car and remove the rear wheels.
2. Support the wheel arm and remove the wheel arm
bolt at the wheel side. See fig. 1
3. Carefully lower the wheel arm and remove the main
spring.
4. Fit the air hose on the airbag and fit the protection
spring over the filling point of the airbag. See fig. 2
5. 5. Guide the air hose through the small hole of the
filling plate and fit the airbag and filling plate into the
spring. See fig. 2+3
6. Fit the spring. Take care : The filling plate should be
centered in the hole of the wheel arm. See fig. 3+4
7. Support the wheel arm and fit the bolt of the wheel
arm.
8. Put the car back on it's wheels.
9. Guide the air hose along the wheel arm to the centre
of the subframe and connect the air hose with the T-
lock. See fig. 5
10. Lead the air hose through the rubber S . See fig. 5
11. Fit the maximum pressure valve and the minimum
pressure valve behind the panel at the left side.
12. Drill a hole of ø8mm in the cover and fit the filling
valve. Place the pressure sticker next to the filling
valve. See fig 6
8
Publicité
