Kenwood TK-7360 Mode D'emploi page 22

E S
XTERNAL PEAKER
After attaching an external speaker to the transceiver, press the key programmed as External Speaker
to output all received signals through the external speaker.
• The
Press the External Speaker key again to output all received signals only through the built-in speaker.
LCD B
RIGHTNESS
You can cycle the display brightness between high, low, and off by pressing the key programmed as
LCD Brightness.
T - T
IME OUT IMER
The Time-out Timer prevents you from using a channel for an extended duration. If you continuously
transmit for a preset time, the transceiver will stop transmitting and an alert tone will sound. Release
the PTT switch.
A P
UXILIARY ORT
Press the key programmed as AUX to activate the auxiliary port. The auxiliary port is used with
optional boards.
• The
B C
USY HANNEL
If BCL is set up by your dealer, you will be unable to transmit if the channel is already in use.
• "BUSY" appears on the display when you press the PTT switch. Use a different channel
or wait until the channel becomes free.
If your dealer has programmed BCL Override for your transceiver, you can override the BCL by
pressing the PTT switch again, immediately after releasing it, when the channel is busy.
PTT ID
PTT ID is the transceiver unique ID code which is sent each time the PTT switch is pressed and/or
released.
C
OMPANDER
If programmed by your dealer for a channel, the compander will remove excessive noise from
transmitted signals, providing higher clarity of signals.
T P
RANSMIT OWER
Your dealer has programmed a transmit power level for each channel. Power levels can be high or low.
16
icon appears on the display.
BACKGROUND OPERATIONS
(TOT)
icon appears on the display when the auxiliary port is active.
L (BCL)
OCKOUT