Kenwood TK-7360 Mode D'emploi page 18

3 Press / (if the key assignment list selection is confi gured as "Enabled") or <B/C> to select
the ID of the station you want to call.
• You can also enter the station ID directly by using the keypad.
4 Press the PTT switch and begin your conversation.
• You can also press
■ Receiving
If enabled by your dealer, an alert tone will sound and the LED will blink when a Selcall has been
received. To respond to the call, press the PTT switch and speak into the microphone.
■ Identifi cation Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number. Each transceiver
must have its own Fleet and ID number.
Note: The ID range may be limited by programming.
P C
AGING ALL
1 Select your desired zone and channel.
2 Press the key programmed as Paging Call to transmit your PTT List ID, to request a call.
S M
TATUS ESSAGE
Status messages are 2-digit codes ranging from 10 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages can be stored in the stack memory of your transceiver and can
be reviewed after reception. The
■ Transmitting
If programmed by your dealer, you can press the Call 1 ~ Call 3 keys to quickly send
preprogrammed status messages. You can also manually send status messages.
1 Select your desired zone and channel.
2 Press the key programmed as Status or Selcall + Status.
• When pressing the Status key, the target Fleet/ ID is fi xed and cannot be
selected. Skip to step 5 to continue.
3 In Selcall mode, press
<B/C> to select the ID of the station you want to call.
• You can also enter the station ID directly by using the keypad.
4 Press S to enter Status mode.
5 Press / (if the key assignment list selection is confi gured as "Enabled") or <B/C> to select
the status ID you want to transmit.
• You can also enter the status ID directly by using the keypad.
Press the PTT switch or ■ to initiate the status call.
6
■ Receiving
When a status call is received, the
on the display. Press any key to return to normal operation.
12
■
to page the ID, rather than talking.
icon appears when a message is stored in the stack memory.
/ (if the key assignment list selection is confi gured as "Enabled") or
icon will fl ash and the calling ID or text message will appear