Télécharger Imprimer la page

Sonnenkonig Fresco 140 Mode D'emploi page 59

Masquer les pouces Voir aussi pour Fresco 140:

Publicité

Les langues disponibles

Les langues disponibles

Timer operation
When the air conditioner is running, press the «Timer» button to select a time between 0-24 h via the +
and - temperature buttons.
Your selected time is shown on the display by slowly blinking.
Confirm your time setting by pressing the «Timer» button again.
The remaining time is now shown on the display.
To cancel the function press the «Timer» button once and your selected time is deleted.
Swing (air flow)
After turning on the machine, press the «Swing» (2) key and the air vents will continuously swing up and
down. When this button is pressed again, the movement will stop and the air vents will remain in that
position.
Sleep control function
When in cooling mode, press the «Sleep» (1) key to set the temperature. It will increase by 1° C after an
hour and at most it will increase by 2° C after 2 hours.
Press the «Sleep» (1) key again can to cancel the setting.
Watertank
The integrated water tank collects excess condensation water produced during air conditio-
ning and dehumidification. The unit has a warning function which, by means of an acoustic si-
gnal and the illumination of the LED light (W.F.), indicates that the water tank must be emptied.
To empty the tank, move the appliance over a drain or container and remove the screw cap and the sili-
cone plug (white) at the bottom of the appliance. Tilt the appliance slightly to allow the water to drain off.
Finally, reconnect the cover and put the appliance back into operation.
Direct Drainage
You can drain the water directly during operation by using the direct drain (see partial description). Use
a Ø 1.5 cm plastic hose (not included in the scope of delivery.) Make sure that the hose cannot slip and
has no leaks before connecting it to the appliance and starting operation.
6. MAINTENANCE
Caution
Before cleaning, make sure to disconnect the device from any electrical outlet.
Do not use gasoline or other chemicals to clean the device.
Do not wash the device directly.
If the air conditioner is damaged, please contact the dealer or repair shop.
Air filter
If the air filter becomes clogged with dust/dirt, it should be cleaned once every two weeks
Disassembly: Open the air inlet grille and take out the air filter.
Cleaning: Clean the air filter with a neutral detergent in lukewarm (40° C) water and dry it up in the
shadow.
Assembly: Put the air filter back into the inlet grille, place the components back as they were before.
Cleaning the surface of the air-conditioner
First clean the surface with a neutral detergent and a wet cloth, then wipe it with a dry cloth.
All manuals and user guides at all-guides.com
59
EN

Publicité

loading

Ce manuel est également adapté pour:

Fresco 1801000100210001102