Clock 10 - Opto/Spdif Output; Clock 11 - Wordclock Input Rate - Steinberg NEUNDO SyncStation Mode D'emploi

Setting the AES clock outputs in Nuendo
The AES clock output setting can be found below the
"Word Clock Output" settings in the SyncStation Settings
pop-up window.
The AES output settings

Clock 10 - Opto/SPDIF Output

Clock 10-Opto/SPDIF
>Clk Ref I/P >Slink I/P >1x Clk >2x Clk
The SPDIF and Toslink outputs can have a separate set-
ting from the two AES outputs with the same choices for
clock generation (see above). Both outputs will use the
same setting.
• Clk Ref I/P
• System Link I/P
• 1x
• 2x
Please note that the SyncStation back panel optical
!
connector can only be used for SPDIF signals (and
not for ADAT signals).
Setting the Opto/SPDIF outputs in Nuendo
The Opto/SPDIF output setting can be found right next to
the AES settings in the SyncStation Settings pop-up win-
dow (see above).

Clock 11 - Wordclock Input Rate

Clock 11-Wordclock Input Rate
>1x >2x >4x >256x
When using the word clock input as the clock reference, it
may be necessary to determine its input divider if using
word clock rates above 48kHz.
>1x
44.1 or 48kHz standard rates do not need a divider.
>2x
88.2 or 96kHz rates divided by two equal 44.1 and
48kHz, respectively.
>4x
172.4 or 192kHz rates when divided by four yield 44.1 or
48kHz respectively.
>256x
The 256 divider is for Digidesign Superclock only.
Changing the clock input divider in Nuendo
In Nuendo's Project Synchronization Setup dialog, this
option only becomes available when word clock is chosen
as the clock reference.
Setting the word clock input divider.
30
Menu Reference