CAME BXV SDN4V Manuel D'installation, D'utilisation Et D'entretien page 63

RIO-CELL is associated to any function chosen among those available: P1 = reopening during closing; P2 =
reclosing during opening; P3 = partial stop; P4 = obstruction wait.
For programming, see the instructions that come with the accessory.
 This function only appears is the control board has been fi tted with a RIO-CONN card.
F68 Wireless input RIO-CELL
[T2]
RIO-CELL is associated to any function chosen among those available: P1 = reopening during closing; P2 =
reclosing during opening; P3 = partial stop; P4 = obstruction wait.
For programming, see the instructions that come with the accessory.
 This function only appears is the control board has been fi tted with a RIO-CONN card.
F71 Partial opening time
After an opening command from the button connected to 2-3P, the gate opens for an adjustable time of between
fi ve seconds and 40 seconds.
 This function only appears if the Encoder function is deactivated.
U 1 Entering a user
Entering up to up to a 25 users maximum and associating to each one a function chosen among the existing
ones. This must be done via transmitter or other control device (see "ENTERING USERS WITH ASSOCIATED
COMMAND paragraph).
U 2 Deleting a user
Deleting a single user
U 3 Deleting users
Deleting all users.
A 1 Motor type
To set the gearmotor depending on the gate's weight.
A 3 Travel calibration
Automatic calibration of the gate-leaf run (see the TRAVEL CALIBRATION paragraph).
A 4 Resetting parameters
Warning! The default settings are restored and the travel calibration deleted.
A 5 Counting maneuvers
For viewing the number of maneuvers made ( 001 = 100 maneuvers; 010 = 1,000 maneuvers; 100 = 10,000
maneuvers; 999 = 99,900 maneuvers; CSI = maintenance job).
A 6 Motor torque
For adjusting the motor torque from 1 (minimum) to 5 (maximum).
H 1 Version
View the fi rmware version.
0 = Deactivated / P1 (default) / P2 / P3 / P4
5 = 5 seconds /....... / 40 = 40 seconds
1 = Step-step command (open-close) / 2 = Sequential command (open-
stop-close-stop) / 3 = Only open command / 4 = Partial command
OFF = Disable / on = Activated
OFF = Deactivated / ON = Delete all users
1 = 400 Kg / 2 = 600 Kg / 4 = 1,000 Kg
OFF = Disable / on = Activated
OFF = Disable / on = Activated
1 / 2 / 3 / 4 / 5