Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION OF PARTS
1. Cover
2. Housing for the RLB battery charger
3. Gearmotor
4. Anchoring plate
5. Transformer
6. Mechanical limit switch
7. Release cable threading hole
8. Housing for SMA sensors
9. Housing for two emergency batteries
10. Control-board supporting structure
11. Control-board protective cover
GENERAL INSTALLATION INDICATIONS
⚠ Only skilled, qualifi ed staff must install this product.
PRELIMINARY CHECKS
⚠ Before beginning the installation, do the following:
check that the upper slide-guides are friction-free;
•
make sure there is are opening and closing mechanical gate stops;
•
make sure that the point where the gearmotor is fastened is protected from any impacts and that the surface
•
is solid enough;
set up suitable tubes and conduits for the electric cables to pass through, making sure they are protected from
•
any mechanical damage.
12. Control board
13. Control-board supporting plate
14. Housing for UR042 module
15. Housing for the RGP1 module
16. Housing for thermostat with heating rod
17. Release lever
18. Lock
19. Release key
20. Limit-switch fi ns
21. Safety micro-switch
22. Housing for the RGSM001/S module
Publicité
