CAME BXV SDN4V Manuel D'installation, D'utilisation Et D'entretien page 62

F37 Opening slow-down
point
Percentage adjustment of the total gate travel, of the opening slow-down starting point.
 This function appears only is the Encoder function is activated.
F38 Closing slow-down point
Percentage adjustment of the total gate travel, from the closing slow-down starting point.
 This function appears only is the Encoder function is activated.
F49 Managing serial connec-
tion
To enable paired operation or the Came Remote Protocol.
F50 Save data
Saving users and saved settings in memory roll.
 This feature only appears if a memory roll has been fi tted into the control board.
F51 Read data
Uploading data saved in memory roll.
 This feature only appears if a memory roll has been fi tted into the control board.
F52 Passing parameter in
paired mode
Uploading settings from Master to Slave.
 This appears only if function F49 is set to Paired.
F54 Opening direction
For setting the gate opening direction.
F56 Peripheral number
To set the peripheral's number from 1 to 255 for each control board when you have a system with several
operators.
F63 Change COM speed
For setting the communication speed used in the CRP (Came Remote Protocol) connection system.
F65 Wireless input RIO-EDGE
[T1]
Wireless RIO-EDGE safety device associated to a function chosen among those available: P0 = total stop, P7 =
reopening during closing, P8 = reclosing during opening.
For programming, see the instructions that come with the accessory.
 This function only appears is the control board has been fi tted with a RIO-CONN card.
F66 Wireless input RIO-EDGE
[T2]
Wireless RIO-EDGE safety device associated to a function chosen among those available: P0 = total stop, P7 =
reopening during closing, P8 = reclosing during opening.
For programming, see the instructions that come with the accessory.
 This function only appears is the control board has been fi tted with a RIO-CONN card.
F67 Wireless input RIO-CELL
[T1]
10 = 10% of the gate travel (default) / ... / 20 = 20% of the travel
10 = 10% of the gate travel (default) / ... / 20 = 20% of the travel
OFF = Deactivated (default) / 1 = Paired / 3 = CRP
OFF = Deactivated (default) / ON = Activated
OFF = Deactivated (default) / ON = Activated
0 = Deactivated (default) / 1 = Activated
0 = Opening towards the left (default) / 1 = Opening towards the right
1 ----> 255
0 = 1200 Baud / 1 = 2400 Baud / 2 = 4800 Baud / 3 = 9600 Baud / 4 =
14400 Baud / 5 = 19200 Baud / 6 = 38400 Baud / 7 = 57600 Baud / 8
= 115200 Baud
0 = Deactivated (default) / P0 / P7 / P8
0 = Deactivated (default) / P0 / P7 / P8
0 = Deactivated / P1 (default) / P2 / P3 / P4