Meta System Meta HPA Evo Instructions De Montage page 22

In the event of a break-in, the anti-theft system performs a 26 sec. alarm cycle, during which the siren will emit a
modulated sound and the direction indicators will fl ash. To stop the alarm cycle, you can press key B on the radio
remote control or disable the anti-theft system by pressing key A.
NB: if you chose CUSTOM SETTING for the radio remote control, you will need to press key A on the radio remote control to
stop the alarm and B to disable it.
ALARM TRIGGERED WARNING AND ALARM MEMORY
If an alarm was triggered in your absence, the siren will emit a Boop when you disable the anti-theft system with the
radio remote control to warn you that an alarm had occurred. You will be able to see the alarm type from the number of
times the LED fl ashes and comparing it to the table below. The fl ashing LED and corresponding alarm memory will be
cleared when you turn on the vehicle instrument panel, or the next time you enable the anti-theft system.
ALARM TYPE
TRIGGERED
Ultrasonic
Doors
Bonnet
Boot
Auxiliary modules (Positive alarm)
Instrument panel (+15)
Tilt/Shock Sensor
TEMPORARILY DISABLING THE ULTRASONIC PROTECTION
If you want to leave the vehicle with the windows open, you must disable the ultrasonic sensors to prevent false alarms.
To disable volumetric protection, enable the alarm and press key B on the radio remote control within 20 sec. To confi rm
that the volumetric protection has been disabled for the whole time that the alarm is enabled, the LED will fl ash very
fast for the fi rst 20 sec., and the direction indicators will fl ash a few times with the corresponding acoustic signal.
NB: if you chose CUSTOM SETTING for the radio remote control, you will need to press key A on the radio remote control.
DISABLING OPTIONAL MODULES AND VEHICLE TILT/SHOCK PROTECTION
If you want to lock the car and enable the alarm while transporting it on another vehicle or on a ferry, you must disable
any optional modules as well as the tilt and shock protection.
To disable volumetric protection, enable the alarm and press key B on the radio remote control within 20 sec. To confi rm
that the protection has been disabled for the whole time that the alarm is enabled, the LED will fl ash very fast for the
fi rst 20 sec., and the direction indicators will fl ash a few times with the corresponding acoustic signal.
Press the key 3 times to disable ultrasonic, optional, tilt and shock protection.
NB: if you chose CUSTOM SETTING for the radio remote control, you will need to press key A twice on the radio remote control.
LED SIGNAL
Off
Slow fl ashing
Fast fl ashing
Very fast
VISUAL/ACOUSTIC ALARM
MAIN LED SIGNALS
Enabled and in surveillance mode
In initial immunity mode with volumetric protection disabled
22
LED SIGNAL
(fl ashing sequence)
1
2
3
4
5
6
7
CONTROL UNIT STATUS
Control unit disabled or off
In initial immunity mode