Sensor Installation - Meta System Meta HPA Evo Instructions De Montage

ENGINE IMMOBILIZER
An attempt to start the engine with the control unit
enabled actives the internal relay, which opens the
engine immobilizer circuit.
CUT ORIGINAL WIRE
STARTER
MOTOR
Fig. 15
VOLUMETRIC PROTECTION AND TEMPORARY DISABLE
The volumetric protection system uses Echo/Doppler technology and orientable sensors to achieve
high performance and excellent false alarm immunity. The sensitivity set in the factory adequately
protects all vehicles thanks to an automatic system that adapts to the volume to be protected. It is
possible to use the PRG007 PROGRAMMER if you want to vary this setting. To temporarily disable volumetric
protection, use the remote control during the immunity time as described in the user manual.
Fig. 16
IGNITION KEY
BLOCK
INSTALL
AN ADDITIONAL
25 A
RELAY
BLUE

SENSOR INSTALLATION

17
ELECTRIC WINDOW MODULE AND
WINDOW CLOSING DISABLE CONTROL
When the alarm is enabled, a POSITIVE control is given
on the PINK/BLACK wire after a 12 sec. delay to drive the
electric window accessory module.
If you want to enable the alarm without closing the
windows, just press the button/LED button a short time
after enabling the alarm with the radio remote control.
AUXILIARY PROTECTION MODULE
It is possible to use additional modules with the alarm,
and to disable them temporarily as for the volumetric
protection.
For this purpose, there is a positive output line dedicated to
driving the modules (PINK wire) and an input for the alarm
signal generated by them (YELLOW wire).