Standard Kit - Meta System Meta HPA Evo Instructions De Montage

The product has a sensor to detect attempts to lift the vehicle or shocks to it. Use the PRG007 PROGRAMMER to enable
this sensor, and to obtain the best performance, ensure that the control unit is properly secured to a rigid part of the
vehicle.
When using the shock sensor, it is possible use either the PRG007 PROGRAMMER or a manual procedure to adjust its
sensitivity once the control unit has been installed and secured to the vehicle.
MANUALLY ADJUSTING THE SHOCK SENSOR (IF ALREADY ENABLED WITH THE PRG007):
• With the anti-theft system disabled, simultaneously press the button/LED and key A on the radio remote control;
the LED will turn on continuously to indicate that the adjustment can be made.
• Each time you press key A, the sensitivity is incremented by one step, until it reaches the maximum value; each
time you press key B, the sensitivity decreases, until it reaches the minimum.
• You can check the sensitivity during adjustment as the product emits an acoustic signal and fl ashes the direction
indicators every time it detects a shock.
• The product returns to normal operation mode when the instrument panel is activated or one minute after the
last operation performed (adjustment or test).
BUTTON A
ENABLING AND PAIRING THE SIREN, RADIO REMOTE CONTROLS AND ELECTRONIC KEYS
Once you have made the electrical connections to the alarm, connect the vehicle battery, check that the vehicle
instrument panel is off and power up the Meta HPA Evo control unit. As it is new, it will automatically store its
components.
PAIRING THE SIREN: a few seconds after powering up the control unit, it will store the siren that is connected, and
will emit a Boop to confi rm. Wait for the LED to start fl ashing quickly and then continue with storing the radio remote
controls.
PAIRING THE RADIO REMOTE CONTROLS: simultaneously press the 2 keys on the fi rst radio remote control; the LED
will turn off for 2 seconds to confi rm. Repeat the operation for all of the other radio remote controls to be paired, each
time checking that they have been stored successfully.
PAIRING THE ELECTRONIC KEYS: after pairing the radio remote controls, continue with storing the electronic keys
by inserting them in the receptacle one after the other, each time checking that they have been stored successfully.
To complete the storing phase, wait for 1 minute, or activate the instrument panel; if you need to add
other components once storage has been completed, you must use the PRG007 programmer to activate
the pairing phase again.

STANDARD KIT

MANUAL PROGRAMMING OF ADDITIONAL KEYS
It is necessary to have an operational touch key to enable this process:
Insert touch key into receptacle, hold for 5 seconds, until the LED fl ashes rapidly.
New Touch key: Insert into the receptacle.
New Radio Key: Press both buttons, simultaneously. of the new radio key.
The programming window closes after 60 seconds, or on ignition ON.
TILT PROTECTION/SHOCK SENSOR
LED/ELECTRONIC KEYS
SET-UP/OVERRIDE
SWITCH
BUTTON A
OPT ABS0499
CODE
19
BUTTON B
SENSITIVITY