Meta System Meta HPA Evo Instructions De Montage page 16

Only use the existent buttons if they close to earth.
DOORS
GREEN
M134
DIODE
MODULE
OR 1N4002
DIODES
(X4)
ORIGINAL
BUTTON
Fig. 8
ALARM OUTPUT FOR HORN/TELEMATIC DEVICE RELAY
During an alarm cycle, there is negative control on the BROWN wire to drive either the original relay or an additional
one for the vehicle horn or telematic device, as applicable. This negative control may be either direct or alternating, as
selected on the PRG007 PROGRAMMER. Follow the indications in fi gures 11 and 12 for the various types of connection.
NEGATIVE CONTROL
HORN
ORIGINAL
HORN
RELAY
ORIGINAL
HORN
CONTROL
Fig. 11
This product drives the direction indicators with positive signals connected directly to the lamps (fi g. 13) or with
negative signals directly to the Hazard Warning Light button on the vehicle (fi g. 14). It is also possible to extend the
indicator lamp fl ashing time by 25 sec. when the alarm stops. Use the PRG007 programmer to select the desired drive
type and extended fl ashing time.
LIGHT BLUE/GREEN
Fig. 13
PERIMETER PROTECTION
BONNET
TO BE INSTALLED
Fig. 9
INSTALL
ADDITIONAL
RELAY
IF HORN IS
POWERED BY
IGNITION-ON
BROWN
BLINKER DRIVE
LIGHT BLUE
BONNET
PROTECTION
BUTTON
PURPLE
INSERT
IN PIN 13
POSITIVE CONTROL
ORIGINAL
HORN
CONTROL
Fig. 12
Fig. 14
16
BOOT
BOOT
LIGHT
PURPLE
+
ORIGINAL
BOOT
BUTTON
INSTALL
ADDITIONAL
RELAY
HORN
BROWN
DRIVE
LIGHT BLUE/GREEN
FEEDBACK
LIGHT BLUE
Fig. 10