Ordering Information; Guidelines And Standards - ProMinent DULCOTEST BRE 1-mA-10 ppm Mode D'emploi

Ordering Information / Guidelines and Standards

15 Ordering Information

Standard scopes
of delivery • 1 BRE 1-mA-10 ppm sensor or BRE 1-mA-2 ppm or BRE 2-mA-10 ppm
• 1 bottle of electrolyte (50 ml)
• 1 replacement membrane cap and nozzle
• 1 operating instructions
• 1 small screwdriver
Complete set The sensors can be ordered only as a complete set:
• BRE 1-mA-10 ppm
• BRE 1-mA-2 ppm
• BRE 2-mA-10 ppm
Consumable
articles • Set consists of
• 1 membrane cap
• 1 bottle of electrolyte (50 ml)
Accessories • DULCOMETER
• Assembly set
• Two-wire signal lead
• Photometer DT 1 for DPD test
• DULCOMETER
• Sampling tap 25 mm

16 Guidelines and Standards

Declaration
of conformity The bromine sensors BRE 1 and BRE 2 were developed and tested according
to the current European Standards and Regulations. Manufacture is subjected
to a high quality standard, which is assured by European standards and
regulations.
A corresponding EC Declaration of Conformity can be obtained from
ProMinent on request.
48
complete
2 membrane caps and
1 bottle of electrolyte (50 ml)
® D1C Bromine controller
for DLG III
for DGM
2
(2 x 0.24 mm , Ø 4 mm)
®
Simulator
order no. 1006895
order no. 1006894
order no. 1020529
order no. 740048
order no. 792862
order no. 792892
identity code
(see product catalogue)
order no. 815079
order no. 791818
order no. 725122
order no. 1003473
order no. 1004042
order no. 1004739
ProMinent
®