Identity Code Ordering System For In-Line Probe Housing Modules - ProMinent DGMa Mode D'emploi

Identcode

Identity Code Ordering System For In-Line Probe Housing Modules

D G M F l o w H o u s i n g M o d u l e
A Series Version
0
1
2
3
4
DGM A 3
Page 20
Flow monitor module:
No flow monitor
With l/h scale
With gph scale (US)
With flow sensor, l/h scale
With flow sensor, gph scale (US)
Number of PG 13.5 modules:
0 No PG 13.5 modules
1 One PG 13.5 module
2 Two PG 13.5 modules
3 Three PG 13.5 modules
4 Four PG 13.5 modules
Number of 25 mm modules:
0 No 25 mm modules
1 One 25 mm module*
2 Two 25 mm modules*
*assembly set required (791818)
Main material:
T Transparent PVC
Seal material:
0 FPM-A
0
1
9
2 1 T 0 0
Connections:
8 x 5 hose
PVC DN 10 threaded connector
Connector nipple/expansion module
Versions:
®
0 With ProMinent logo
®
1 Without ProMinent logo
Accessories included:
Wall mounting
for PG 13.5 module: calibration cup
PG 13.5 sensor assembly set
The identity code below describes a fully assembled combination of
flow monitor with sensor, two PG 13.5 modules (e.g. for pH and redox
sensor) and a 25 mm module (e.g. for chlorine sensor CLE 3). Fitted with
8 x 5 hose connector.
Recommended accessories:
Sensor mounting kit 25 mm
(CLE, BRE, CGE, CTE, CDE, OZE):
for potential equaliser: plug
flow sensor
additional calibration cup
Sampling Tap for DGM
for 13.5 module
for 25 mm module
FPM = Fluoroelastomer
0
Order No.
791818
791663
791635
791229
1004737
1004739
ProMinent ®