Maruyama MSB15LiZ EU Manuel Du Propriétaire page 7

2). Shoulder band
Adjust the band length as follows:
(1) To shorten band
Pull the sling downward along the front hanging
band.
3. Handling and operating method
Nozzle assembling
First ensure that the gasket is put in place, screw
the lance into the grip, and tandem nozzle head
into the lance. In that step, check the gasket in
place to prevent water leakage, and then tighten
the screw securely. Be sure to tighten it while
refraining the excessive tightening, which will
cause the gasket to stick out.
Checking the battery remainder (Battery remainder determination method)
(1) Pour approximately 1 liter of water into the chemical tank.
(2) Turn the switch ON, wait until the pump sucks water to raise the pressure, and then check the graduation
of the battery balance meter.
Recharging
Yellow
Must be recharged
Red
CAUTION
● Be sure to pour water in the chemical tank before inspection. Otherwise, the pump runs without load
and may causes a failure.
● Make it a rule to recharge the battery if the pointer approaches the yellow zone, even if it is still in the
green zone.
(2) To lengthen the band
Insert the front handing band upward.
Grip
Operable
Green
Green
Yellow
Red
For recharging details,refer to descriptions on Page 9.
If operation continues after the remaining battery icon
turns red, this product automatically turns off.
- 6 -
Gasket
(Grip end)
Operable
Recharging
Must be recharged
Tandem nozzle head
Gasket
(Lance end)
Lance
English