Publicité
Attach the IP Phone to the Stand (See Figure
Turn the phone so that the front faces away from you.
Hold the stand so that the lower hooks on the front of the stand are towards
the bottom edge of the phone.
Hinge the hooks on the stand into the lower notches on the back of the
phone and snap into place.
D
Connect Cables to Stand
• Connect the short CAT 5 LAN cable to the LAN port. See
• Connect the power supply adapter cable to the power input jack. See
B
.
• Attach the appropriate voltage connector plug to the power supply adapter.
• Plug the power supply adapter into an appropriate wall outlet. Ensure the power LED
on the IP DECT stand turns green.
Install Handset Batteries
• Release the battery cover at the bottom of the back panel and remove.
E
• Insert the Li Polymer cell battery in the handset as shown below:
6
D
)
B
in Figure
.
in Figure
F
• Replace the back panel and slide shut.
Set Up Handset Charger
• Connect the appropriate power adapter to the handset charging cradle.
• Attach the appropriate voltage connector plug to the power supply adapter.
• Plug the power supply adapter into an appropriate wall outlet.
• Place the handset in the charger. When you place the first handset in the charger, the
handset automatically registers with the IP DECT Stand. After the first handset is
registered, there is a 5 minute period during which you can register addtional
handsets. To register additional handsets after the 5 minute period has expired, you
must press the Reset button on the stand to start a new 5 minute registration period.
G
• Ensure the power LED turns green.
• Charge the battery. We recommend that you charge the battery fully before first use. It
takes approximately 10 hours to fully charge the battery. Normally, it takes
approximately 6 hours to charge the battery.
Configuration Requirements
You must complete the following configuration before the cordless handset is
fully functional:
Publicité
