Télécharger Imprimer la page

Indel Marine Isotherm 3201 ASU Instructions D'installation Et D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

Indicator lights
Green:
Green+yellow:
Green+red:
Green+yellow+red:
Green and flashing
yellow+red:
Green and flashing
yellow:
Note: The compressor will start 30 seconds
after switching on. When the engine is
started, ½-10 minutes is required (depending
on the boats charging equipment and battery
condition) before the system reacts. When
the engine is stopped, ½-5 minutes is
required (depending on battery condition and
level of charge) before the system reacts.
Maintenance
If the quick-coupling connections have been
tightened correctly during installation, the
totally hermetic ISOTHERM system will never
require refilling with refrigerant. Maintenance
is limited to removing dust on the condenser
radiator with a brush, cleaning the fan,
defrosting the holding plate when required
and keeping the inside of the refrigerator dry.
It is of vital importance that the batteries and
charging system are kept in good condition.
Safety Instructions
- When connected to shore-power, ensure
that the power supply system is equipped
with an ground fault circuit interrupter.
Danger!
- Never touch bare electric wiring connected
to the mains supply. Danger!
- Never open the cooling circuit except by the
quick couplings, which are designed
specifically for that purpose.
- Never connect a battery charger directly to
the refrigeration system. It must always be
connected to the battery. In addition to acid,
a newly charged battery contains explosive
gas. Danger!
- Never cover up the ventilation openings for
the compressor unit.
Power and system on, but compressor at standstill due to
sufficiently low temperature of holding plate.
Compressor running within the higher temperature range.
Compressor running at high speed within the lower temperature
range.
Compressor running at lowest possible speed to reach selected
temperature in MAN. TEMP mode.
Error signal from electronic unit. Automatic re-start after
1 minute.
Low battery voltage sensor has switched off the system
Automatic re-start occurs when engine is started to charge
batteries again.
Environment
This product is marked according to the
European directive 2002/96/EC on Waste
Electric and Electronic equipment /WEEE).
By ensuring this product is disposed of
correctly, you will help prevent potential
negative consequences for the environment
and human health, which could otherwise be
caused by inappropriate waste handling of
this product.
The symbol
on the product, or on the
documents accompanying the product,
indicates that this product may not be treated
as household waste. Instead it shall be
handed over to the applicable collection point
for recycling of electrical and electronic
equipment. Disposal must be carried out in
accordance with local environmental
regulations for waste disposal. For more
detailed information about treatment,
recovery and recycling of this product, please
contact your local city office, your household
waste disposal service or the shop where you
purchased the product.

Publicité

loading

Ce manuel est également adapté pour:

Isotherm 3701 asu