Ford VML3Z-84501A42-B Addendum page 8

20
Install the prop rod by
snapping the knuckle
end onto the bracket.
22
IMPORTANT
While driving, cover must be completely flat and secure with all latches in the closed position OR completely
folded up (all panels) and secured at the cab. DO NOT DRIVE with cover partially opened.
Tonneau Cover Positions While Operating Vehicle
Prior to vehicle operation, tonneau cover MUST be properly secured.
CLOSED POSITION
All panels must be closed and FULLY LATCHED to tonneau side rail.
All panels must be flat and latches engaged
FOLDED UP POSITION
To drive with your cover in the folded up position, simply make use of the
tie down straps and buckles provided with your cover. Ensure BOTH buckle
clips are fully inserted into the buckle ends located on the front header panel
of the cover and adjust the straps to ensure the cover is secure during
IMPORTANT NOTICE:
vehicle operation.
storage position buckle ends located on the cover latch housing when not in use.
FLIPPED UP POSITION
A) Fold the cover open and lift it until its vertical or past
90 degrees towards your truck cab. Then release the prop
rod that is attached to your rail. Fold the prop rod over
and position it firmly against the vertical plate on the
underside of your cover. Then slide the prop rod
locks downwards and tighten the knobs to lock
into position. Do this on both sides of the cover.
B) Your cover should be firmly in
position with little to no movement
once the prop rods are locked.
Rev Industries HFC
Clip the prop rod into
the clip for storage
when not in use.
Safe operation and use
IMPORTANT NOTICE
The clips should be secured in the
21
Sometimes, your side seals of your cover
will appear to be wrinkled shortly after
initially installing the cover. To assist seals
in laying flat you can leave your truck in the
sun, or to expedite, just apply heat with a
hair dryer or heat gun.
STORAGE
POSITION
FOR CLIP
FLIPPED UP: B
FLIPPED UP: A
Check to see that cover
panel latches make
proper contact with
side rails. Adjust cover
fit as necessary.
FOLDED UP POSITION
Part# 318A0080 Rev. 7.23.2020