Publicité
Les langues disponibles
Les langues disponibles
Mounting grip rod
Make sure that the Bowden cable
(
5) is not crushed during the as-
sembly of the grip handle.
1. Fold the bottom handle (4) and
the upper grip handle (1) up-
wards.
2. Bring the bottom handle (4) into
the desired position and lock
the quick-release levers (21) by
pushing them in the direction of
the handle (4). The quick-release
lever should be facing upwards.
tensioning with medium force can
be carried out.
Otherwise, the quick-release le-
vers must be turned clockwise for
tensioning them or anti-clockwise
to loosen them.
3. The bottom handle (4) has
two separate mounting holes.
Mount the grip handle at the
desired height onto the bottom
handle (4) with the aid of the
quick-release lever.
4. Lock the quick-release levers (25)
to the upper grip handle (1) as
described below 2.
5. Fasten the Bowden cable (
5) using a cable clamp (
the bottom handle (
Fitting the starter cord
1. Pull the safety bar (2) towards the
grip handle (1) and hold it in this
position.
2. Slowly pull the starter cord by
the starter handle (7) in the direc-
tion of the handlebar and hang
Installing the Grass Collection
Box
6) to
4).
the starter cord in the starter cord
guide (3).
3. Release the safety catch (2).
Caution: Do not operate the
equipment with the grass col-
lection box or impact protec-
tion installed incompletely.
Risk of injury!
Mounting the net
1. Put the plastic straps (28) on the
grass catcher (20) over the grass
catcher rod (29).
Fixing the Grass Collection
Box onto the Equipment:
2. Lift the rear impact protection
(22).
3. Hold the grass collection box
(20) by the carrying handle (23)
and hang it on the grass collec-
tor hanger (30) at the rear of the
device which is provided for this
purpose.
Dismantling the Grass Col-
lection Box:
4. Raise the impact protection (22)
and remove the grass collection
box (20) by the carrying handle
(23).
GB
IE
NI
75
Publicité
