AMATECH Maquet Little Leg Holder Instructions D'utilisation page 12

INSTRUCTIONS FOR USE
2.6 Residual risk:
This product complies with relevant performance, safety standards. However,
patient harm from misuse, device, function or mechanical hazards cannot be
completely excluded.
3 Equipment Setup and Use:
3.1 Prior to use:
a. Inspect the product looking for any visible damage or sharp edges that could
be caused by a drop or impact during storage.
b. Make sure product has been properly cleaned and disinfected and wiped dry
prior to each use.
c. Prior to setting up the stirrups, assess the patient for any pre-existing conditions
that might contraindicate the use of leg positioning devices.
3.2 Setup:
1. Position the Rail Clamps adjacent to the patient's hip.
2. Attach the Stirrup to the table rail by sliding the Stirrup Post Mount into the slot on
the top of the Rail Clamp. Left and Right Stirrups must be in the exact same
location on opposite sides of the operacinės table. As shown in figure 1.
NOTE: Ensure Left and Right Stirrups are on the proper side; the Boots are marked
(on the bottom of the Boot) for the patient's left and right.
CAUTION: Avoid pinching fingers between rail and clamp body.
WARNING: Once the Stirrup is placed on the rail, the Rail Clamp must be
tightened securely before use.
Document Number: 80028291
Version: B
Blade
Rail Clamp
Page 12
Issue Date: 10 AUG 2021
Ref Blank Template: 80025118 Ver. E