Lubricating The Chain; Sharpening The Saw Chain; Operation; Switching On And Off - FLORABEST FHEHS 900 B2 Mode D'emploi

Lubricating the chain

♦ Remove the oil filler cap .
♦ Fill the oil tank with approx. 100 ml of organic chain oil
WARNING!
► Never work without lubricating the chain first!
If the saw chain runs dry, the cutting equipment may become irrepar-
ably damaged within a short time. Always check chain lubrication
and oil level in the tank before starting work.
NOTE
► Use only saw chain oil. Preferably biodegradable. Do not use waste
oil, motor oil, etc.
► Check whether the automatic chain lubrication is working correctly
while working. Check the chain lubrication before and during work.

Sharpening the saw chain

NOTE
► A bench grinder can be attached to the bench grinder support
a secure grip during grinding.
► You will find detailed information on sharpening in a sharpening set,
e.g. from Oregon.
► Alternatively, you can use an electrical saw chain sharpening device
and follow the manufacturer's instructions.
► If you have any doubts about carrying out the work, the saw chain
should be replaced.

Operation

NOTE
► Comply with regulations regarding noise protection and local rules.
Using the appliance on certain days (e.g. on Sundays and public
holidays), during certain times (midday, night time) or in certain
locations (e.g. health resorts, clinics, etc.) may be restricted or
prohibited.
Switching on and off
Switching on:
♦ Connect the power cable
♦ Form a loop at the end of the extension cable and attach this to the
strain relief .
♦ Press the safety lock-out and keep it pressed and then press the
On/Off switch .
Switching off:
♦ Release the On/Off switch
♦ Remove the extension cable from the strain relief
♦ Disconnect the power cable

Adjusting the handle

♦ Press the release button . Turn the turning element
position. Let go of the release button
FHEHS 900 B2
to the extension cable.
.
.
from the extension cable.
to the desired
; this must click into place.

Working with the hedge trimmer

Use of the machine:

.
NOTE
► Please note that legal restrictions in your country may limit your use
of the hedge trimmer.
► The daily inspection of the hedge trimmer before each use is
indispensable. Also check the appliance after knocks and drops to
rule out any significant damage or defects.
► Wear sturdy shoes and snug-fitting clothing to reduce the risk of
accidents. Stand firmly on the ground, pay attention to your balance
and always wear the supplied carrying strap!
► For the sake of your health, take regular breaks while working.
Physical fatigue increases the risk of injury!
WARNING!
► Never use the appliance when you are tired or ill or under the in-
fluence of alcohol or other drugs or medications.

Cutting techniques

for
■ See fold-out page (Figure A).
NOTE
► Remove thicker branches with a branch cutter.

Working with the pole pruner

Sawing techniques

WARNING!
► Always pay attention to the falling clippings.
► Be aware of the danger of branches swinging back.
NOTE
► Place the stop
and quietly.
► Now you can begin sawing.
Sawing off small branches
♦ Saw small branches (Ø 0–8 cm) from the top down (see figure).
on the branch. This will help you work more safely
GB │ IE │ NI
9
■
│