Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RANGER PROSPECTOR PRO SR TRACK KIT
KIT PN 2878074
6.6. Structure Replacement
WARNING
Adjustment should be made by a dealer or a
competent mechanic.
The following steps refer to one structure. However, all
structures follow the same procedure for installation and
removal.
1. Raise the UTV off the ground.
WARNING
When the UTV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the
tracks. If not properly secured/supported, serious
physical injury could occur.
2. Remove the track following the procedure described
in section 6.1. - Track replacement.
3. Remove the structure assembly from the main axle
following the procedure described in section 6.2. -
Sprocket and main axle replacement.
4. Remove wheels from structure following the
procedure described in section 6.3. - Wheels
replacement.
5. Replace structure. To reassemble the kit, reverse the
steps and apply the torque listed in Table 1 - Torque
specifications.
6. Lubricate main axle bearings using good quality
bearing grease as shown in the maintenance section.
WARNING
Apply Loctite 242 adhesive on threads where needed
in different sections and use necessary care not to
damage any parts while removing them.
If washers or spacers on anti-rotation retaining
bolts are deformed, replace them.
2510309
A-2510309-1
6.7. Anti-Rotation Replacement
The following steps refer to one anti-rotation assembly.
However, all anti-rotation assembly follow the same
procedure for installation and removal.
6.7.1. Front Anti-Rotation Replacement
1. Unscrew and remove the 3/8" bolt, 3/8" nut, flat
washers, and spacer fixing anti-rotation to the
structure.
2. Unscrew and remove the 1/2" nut and the two ball
joint spacers retaining the anti-rotation ball joint on
the sub-table.
3. Replace the parts.
4. To reassemble the kit, reverse the steps and apply
the torque listed in Table 1 - Torque specifications.
Figure 37 - Front anti-rotation view
5. To adjust the front anti-rotation, refer to section 3.1.
- Front Track Kit adjustment.
6.7.2. Rear Anti-Rotation Replacement
1. Unscrew and remove the 5/8" nylock nut from
threaded section of anti-rotation tube.
2. Unscrew and remove the 3/8" bolt as well as 3/8"
nut, flat washers, and spacer fixing anti-rotation on
structure.
3. Replace the parts.
- 26 -
Publicité
Table des Matières
