Sprocket And Main Axle Replacement; Figure 26 - Direction Of Rotation Of The Front And Rear Tracks; Figure 27 - Removal Of The Front And Rear Anti-Rotation Assemblies - Polaris PROSPECTOR PRO SR Manuel D'installation

RANGER PROSPECTOR PRO SR TRACK KIT
KIT PN 2878074
6. Remove the track.
WARNING
When you install the track, pay particular attention
to its direction. An arrow on the track points towards
the front of the vehicle when looking from the top.
FRONT
REAR

Figure 26 - Direction of rotation of the front and rear tracks

7. Reverse procedure to install track.
8. Adjustment are performed as follows : Refer to
section 3.3 for track tension adjustment.
2510309
A-2510309-1

6.2. Sprocket and Main Axle Replacement

The following steps refer to one sprocket and main axle.
However, all four sprockets and main axles follow the
same procedure for installation and removal.
1. Raise the UTV off the ground.
WARNING
When the UTV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the
tracks. If not properly secured/supported, serious
physical injury could occur.
2. Remove the track following the procedure in
section 6.1. - Track replacement.
3. Unscrew the bolt and nut connecting the structure
and the anti-rotation assembly.

Figure 27 - Removal of the front and rear anti-rotation assemblies

- 21 -