Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RANGER PROSPECTOR PRO SR TRACK KIT
KIT PN 2878074
3.3. Track Tension Adjustment
As stated earlier in this manual, the track will to stretch
during your first ride. To prevent premature wear of
components or failure that a loose track may cause, here is
the way to adjust track tension. The following steps refer
to one track. However, all of the tracks follow the same
procedure for tension adjustments.
Please note : Some parts had been hidden in following
figures for a better understanding.
1. Align the track adjustment hole with the 1/2"
adjustment bolt of the track adjuster.
Figure 15 - Alignment of the track adjustment hole
2. Loosen the 3/8" nut retaining the track adjuster to
the structure.
Figure 16 - Nut of the track adjuster
3. Loosen the 1/2" jam nut (A) of the adjustment bolt
on the track adjuster using the track tension
adjustment tool (B).
2510309
A-2510309-1
Figure 17 - Track tension adjustment tool
4. Put a straight edge on track as shown (see Figure 18).
Front right
shown
Figure 18 - Adjusting the track tension
5. Apply a force at mid point while measuring the
track deflection.
6. Adjust the track tension by screwing or unscrewing
adjustment bolt until the track adjuster moves.
7. Repeat steps 4 to 6 until the track tension is within specs.
8. Tighten bolts, nuts and jam nut which were
loosened in steps 2 and 3.
WARNING
Do not overtighten the track, a performance loss or
component damage may occur.
- 17 -
Rear right
shown
Publicité
Table des Matières
