Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RANGER PROSPECTOR PRO SR TRACK KIT
KIT PN 2878074
SECTION 6 : PARTS REPLACEMENT
WARNING
Always clean the Track Kit after use to prevent
debris accumulation inside the frame. Failure to do
so will result in premature wear of components.
WARNING
Never use solvants to clean rubber tracks as these
substances may cause rapid degradation of the
rubber. Use only water with mild detergent.
6.1. Track Replacement
The following steps refer to one track. However, all four
tracks follow the same procedure for installation and
removal.
1. Raise the UTV off the ground.
WARNING
When the UTV is raised, make sure that it is
properly secured/supported to prevent it from
accidentally falling during the installation of the
tracks. If not properly secured/supported, serious
physical injury could occur.
2. Unscrew the 3/8" nut retaining the track adjuster to
the structure.
Figure 22 - Thin nut of the track adjuster
2510309
A-2510309-1
3. Loosen the 1/2" jam nut (A) of the adjustment bolt
on the track adjuster using the track tension
adjustment tool (B).
Figure 23 - Track tension adjustment tool
4. Unscrew the adjustment bolt completely.
Figure 24 - Removal of the adjustment bolt
5. Remove the two large wheels placed opposite the
track adjuster following the procedure in section
6.3.2. - Large wheel replacement.
Figure 25 - Removal of the large wheels
- 20 -
Publicité
Table des Matières
