Sony LMD-X310S Avant D'utiliser Cet Appareil page 25

Caution
When installing, ensure the following space around the
periphery of the unit, taking ventilation and servicing into
consideration.
5
– Rear side: 4 cm (1 / in.) or more
8
– Left/Right sides: 10 cm (4 in.) or more
3
– Bottom side: 6 cm (2 /
8
7
– Top side: 30 cm (11 / in.) or more
8
Consult with Sony qualified personnel for the following
types of installation location.
– Wall mount
– Floor mount (LMD-X310S only)
Caution
Do not use the device in a MR (Magnetic Resonance)
environment.
It may cause a malfunction, fire, and unwanted
movement.
Caution
For safety, do not connect the connector to peripheral
device wiring that might have excessive voltage.
Follow the instructions for use for the LAN port.
WARNING
Using this unit for medical purposes
The connectors on this unit are not isolated.
Do not connect any device other than one which conforms
to IEC 60601-1 standards.
When an information technology device or AV device that
uses an alternating current is connected, current leakage
may result in an electric shock to the patient or operator.
If use of such a device is unavoidable, isolate its power
supply by connecting an isolation transformer, or by
connecting an isolator between the connecting cables.
After implementing these measures, confirm that the
reduced risk now conforms to IEC 60601-1 standards.
Caution
This unit with the connector cover attached conforms to
the waterproofed standard. (LMD-X310S: See page 15,
LMD-X550S: See page 16)
Be sure not to use the unit with the connector cover
removed since waterproofed performance is not
guaranteed.
in.) or more
Caution
Do not remove screws other than the two screws fixing the
clamp when you remove the cable clamp inside of the
connector cover. Doing so may cause electric shock.
LMD-X310S only
Caution
Connect the DC connector to the unit, then connect the
power cord of the AC adaptor.
To remove the DC connector, remove the power cord of
the AC adaptor, then remove the DC connector.
WARNING
For the DC power supply, make sure to use the supplied
AC adaptor, AC-300MD.
If another power supply is used, there is a risk of fire or
electric shock.
LMD-X550S only
WARNING
To avoid the risk of electric shock, this
equipment must only be connected to a supply
mains with protective earth.
WARNING
This unit has no power switch.
To disconnect the main power, unplug the power plug.
When installing the unit, incorporate a readily accessible
disconnect device in the fixed wiring, or connect the
power plug to an easily accessible socket-outlet near the
unit.
Do not position the ME equipment where it is difficult to
unplug the power plug.
If a fault should occur during operation of the unit,
operate the disconnect device to switch the power supply
off, or disconnect the power plug.
9
GB