Sony LMD-X310S Avant D'utiliser Cet Appareil page 24

Guidance and manufacturer's declaration – electromagnetic immunity
The LMD-X310S/X550S is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled. Portable RF communications equipment should be used no closer than 30 cm (12 inches) to any part of the
LMD-X310S/X550S. Otherwise, degradation of the performance of this equipment could result.
Immunity test
Proximity fields
from RF wireless
communications
equipment
IEC 61000-4-3
NOTE: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
a For some services, only the uplink frequencies are included.
Caution
When you dispose of the unit or accessories, you must
obey the laws in the relative area or country and the
regulations in the relative hospital regarding
environmental pollution.
WARNING
The apparatus shall not be exposed to dripping or
splashing. No objects filled with liquids, such as vases,
shall be placed on the apparatus.
8
GB
a
Band Service
380 – 390 MHz TETRA 400
GMRS 460
430 – 470 MHz
FRS 460
704 – 787 MHz LTE Band 13, 17
GSM 800/900
TETRA 800
800 – 960 MHz iDEN 820
CDMA 850
LTE Band 5
GSM 1800
CDMA 1900
GSM 1900
1,700 – 1,990 MHz DECT
LTE Band 1, 3, 4,
25
UMTS
Bluetooth
WLAN
2,400 – 2,570 MHz 802. 11 b/g/n
RFID 2450
LTE Band 7
5,100 – 5,800 MHz WLAN 802. 11 a/n
a
Modulation
Pulse modulation
18 Hz
FM
±5 kHz deviation
1 kHz sine
Pulse modulation
217 Hz
Pulse modulation
18 Hz
Pulse modulation
217 Hz
Pulse modulation
217 Hz
Pulse modulation
217 Hz
WARNING
To prevent injury, if mounting the unit using a mounting
arm, wall fixture, or other mounting device prepared by
the customer, mount the unit securely as described in the
instruction manual provided with the mounting device.
When fixing the unit, use more than 4 of the supplied
screws for the VESA mount or specified screws.
Fasten the screws to the hole positions firmly and
symmetrically to the upper and lower, left and right
positions towards the center of the monitor.
Check beforehand that the mounting device used has
sufficient strength to support the added weight of the unit.
Check yearly that the mounting device is securely
attached.
IEC 60601
Compliance level
test level
27 V/m 27 V/m
28 V/m 28 V/m
9 V/m 9 V/m
28 V/m 28 V/m
28 V/m 28 V/m
28 V/m 28 V/m
9 V/m 9 V/m