Table des Matières
Publicité
46
8.8
CHILD PROOF FUNCTION
This function will lock the keys to avoid unsupervised operation.
A.
Press the MODE and UP keys at the same time.
B.
To de-activate this function, press the MODE and UP keys at the same time.
8.9
CRYSTALITES
The auxiliary function controls the AUX power outlet on
the Control Module which controls the Crystalites™.
A.
Use the Mode Key to guide you to the AUX
icon.
B.
Pressing the Up Arrow Key will activate the
Crystalites™.
C.
Pressing the Down Arrow Key will turn the
Crystalites™ off. A single "beep" will confi rm the reception of the command.
8.10 LOW BATTERY / MANUAL BYPASS
The life span of the remote batteries depends on various factors: quality of the
batteries, the number of ignitions, the number of charges to the room thermostat set
point, etc.
When the transmitter batteries are low, a Battery Icon will appear on the LCD
display before all battery power is lost. When the batteries are replaced this icon will
disappear.
Not applicable when plugged into 110V.
When the receiver batteries are low, no "beep" will be emitted from the receiver
when it receives an ON/OFF command. This in an alert for the receiver that there's low battery. When the
batteries are replaced the "beep" will be emitted from the receiver when the ON/OFF key is pressed.
If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding the
three position slider switch on the receiver to the "ON" position. This will bypass the remote control feature and
the appliance main burner will come on if the gas valve is in the "ON" position.
8.11 IN THE EVENT OF A POWER FAILURE
If the receiver is equipped with batteries they will enable fl ame height control, ON/OFF or thermostat
function to control the fi replace during a power failure. Refer to "APPLIANCE OPERATION" section when
communications between receiver and transmitter have been lost. The will receiver emit a "beep" sound to
confi rm programming has been successful once power is restored. During a power failure, if the fi replace was
on, the fl ame height will stay at the setting prior to the failure. If off when the failure occurs and then turned on,
the fl ame height will come on at "HI". The fl ame height can then be controlled by the remote.
W415-0745 / E / 08.15.12
TM
76
°F
ON
SMART
OFF
76
°F
ON
35.10
76
°F
ON
SMART
ON
35.11
76
°F
ON
35.13
35.14
Publicité
Table des Matières
