Publicité
Les langues disponibles
Les langues disponibles
AIR PANEL P-AP56NAMR
9.3 INSTALLATION
!
C A U T I O N
•
Turn OFF the power source completely before performing the dip
switch setting, installation work and electrical wiring work for receiver
kit. If not, it may cause an electric shock.
•
Perform securely the installation work referring to this installation
manual. If the installation is not completed, it may cause injury by
falling down the receiver kit.
•
Do not install the receiver kit where the flammable gases may
generate or enter. It may cause heat generation or a fire.
•
Perform securely the electrical wiring work. If the electrical work is
not completed, heat generation at the connection, a fire or an electric
shock may occur.
•
Make sure that the electrical wires are securely fixed in order not to
apply an external force to the terminal connections of the wirings. If
fixing is not completed, it may cause heat generation or a fire.
1 Perform the installation work for receiver kit while the
optional air panel is being attached to the indoor unit.
2 In the case that the receiver kit is attached after the air panel
is attached to the indoor unit, turn OFF the power source
of indoor unit, and remove the air panel. The removing air
panel should be performed according to the installation
manual of the air panel or the service manual.
3 This receiver kit can be attached to any of corners (4
directions,
,
,
, and
place as user's request.
?
N O T E
The dip switch setting for receiver kit is available to select each
function. If the optional function selection is required, it shall be
performed according to the item "9.9 Optional functions for receiver
kit" before the receiver kit is attached to the air panel.
4 Attach the air panel.
The installation of air panel should be referred to the
installation manual of itself.
5 After the installation work for air panel is completed, attach
the receiver kit.
a. Removing the corner pocket cover.
Remove the corner pocket covers by pulling
towards the arrow direction.
b. Catch the band at the rear side of the receiver kit onto
the projection at the air panel as shown in the figure.
?
N O T E
Catch securely the band onto the projection to prevent falling
down the receiver kit.
16
PMML0570 rev.0 - 01/2021
). Determine the attaching
A
part
?
N O T E
•
When the receiver kit is attached near lighting which generates the
ambient light, it may not receive the signal from the wireless remote
control. Pay attention to the installation position of receiver kit.
•
Do not run the connecting cable for receiver kit and the power source
cable in parallel. It may cause malfunction of receiver kit by noise.
Air Panel
Air panel
1
4
Projection
Strap
Ⓐ
Fixing hook
2
3
A
Ⓑ
Fixing hook
Publicité
