Publicité
Les langues disponibles
Les langues disponibles
AIR PANEL P-AP56NAMR
9.7 OPERATION WITH WIRED REMOTE CONTROL SWITCH
The indoor unit can be operated by both wired and wireless
remote control switches. Contact your distributor and contractor
for detail.
9.8 AUTOMATIC OPERATION
Refer to the installation and operation manual of the indoor unit.
9.9 OPTIONAL FUNCTIONS FOR RECEIVER KIT
!
D A N G E R
Turn OFF the power source completely before performing the dip switch setting for receiver kit. If not, it may cause an electric shock.
1 The following switches are on the receiver kit.
Timer
2 Emergency operation setting
"Cool" and "Heat" switches are used for emergency
operation when the batteries for wireless remote control
switch are shortage.
a. Switch "Cool": press "Cool" so that the cooling operation
is started.
Press "Cool" again so that the cooling operation is
stopped.
b. Switch "Heat": press "Heat" so that the heating operation
is started.
Press "Heat" again so that the heating operation is
stopped.
?
N O T E
During the emergency operation, "
ON / 0.5 second OFF). The setting temperature and the fan speed for
cooling/heating operation are the same as before starting emergency
operation.
19
PMML0570 rev.0 - 01/2021
ON
1 2 3 4 5 6
Dip switch (DSW1)
(Factory-setting)
Filter
Def
Run
Emergency
Heat
Cool
Switch "Heat"
Switch "Cool"
" lamp (yellow) flashes (0.5 second
Wired remote
control switch
(PC-ARF**)
PCB
Cover
Rear side of
receiver kit
3 The dip switch (DSW1) is for the optional function selection.
If the optional function selection is required, set the DIP
switch as follows.
Wireless remote
control switch
(PC-AWR)
Remove the
screw
Publicité
