Publicité
Les langues disponibles
Les langues disponibles
AIR PANEL P-AP56NAM
7.3 ELECTRICAL WIRING OF AIR PANEL P-AP56NAM
CN17
Connector
Air panel
!
C A U T I O N
•
Perform securely the electrical wiring work. If the electrical work is
not completed, heat generation at the connection, a fire or an electric
shock may occur.
•
Make sure that the wires are securely fixed in order not to apply an
external force to the terminal connections of the wirings. If fixing is not
completed, heat generation or a fire will occur.
1 The following connectors are used in the air panel. Remove
the tape fixing the wiring connectors on the air panel and pull
out them as shown in the figure below. Connect them with
the wiring connectors to CN17 in the electrical box as the
following figure.
?
N O T E
Before the electrical wiring work, turn OFF the power source. If the
connectors are connected without turning OFF the power source, the
auto swing louver can not activate.
7
PMML0570 rev.0 - 01/2021
(CN17)
ON
1 2
Earth screw
PCB
ON
1 2
Electrical box
Indoor unit
Wire clamp
Control cable
Remote control switch cable
Power source cable
Cable for auto swing motor
2 After completing the wiring connection of the air panel,
attach the air inlet grille. Perform the attaching work in the
reverse procedure of removing. Hook the swivel of the
supporting string at
inlet grille can be attached from any 4 directions by rotating
it. When multiple indoor units are installed or requested from
a user, the air intake grille direction can be selected freely.
Hole at air panel
Ⓐ Part
to the hole at the air panel. The air
Ⓐ
Supporting string
Publicité
