Videotec ULISSE RADICAL Manuel D'instructions page 31

9.1.14 Factory Default
If the access password to Pan & Tilt is no
longer available, follow the procedure to
reset to default settings using the Reset
key, situated inside the product.
To search and identify the Pan & Tilt,
following the instructions in the relevant
chapter (9.1 Web interface, page 21). In this
case however, the access credentials to the
system are those of the camera and not Pan
& Tilt. If the credentials are those of camera
default (set by Videotec) they are:
Login: service
Password: Videotec2020-
To restore the factory settings relative to the network,
user access and camera configuration follow this
procedure:
• Power the unit.
• Open the cover of the DIP-switches.
• Detect DIP switch 4 (01). Bring switch 1 down, 1
(ON) value.
• Wait for the temporary shutdownf of the LEDs (02).
• Bring switch 1 up, 0 (OFF) value.
• Close the connector housing cover.
• Follow the instructions in paragraph 9.1 to search
the address (9.1 Web interface, page 21).
Fig. 67
MNVCUPKHXL_2222_EN
01
02
The required parameters are:
• The IP protocol used to communicate with the
camera (ONVIF PROFILE S).
• The type of lens installed (MOTORISED).
• The credentials necessary for connection to the IP
camera (username: "service";
password: "Videtotec2020-").
• Restart the device.
• If still set in DHCP, the product could have changed
address.
Fig. 68
29