Videotec ULISSE RADICAL Manuel D'instructions page 22

7.11 Fastening of the wiper blade
Insert the blade on the wiper shaft.
Position the blade in the stop position.
Fig. 35
Fasten the whole assembly by means of the washer
and nut.
Fig. 36
The correct adjustment must allow the
return of the blade to the stop position
going to the end stop on the casing's plate.
20
8 Switching on
Ensure the unit and the other components
of the system are appropriately closed to
prevent contact with live parts.
During normal operation the surface of the
illuminator can reach high temperatures.
Do not allow direct contact and position
the appliance where it is inaccessible to
unauthorised persons. Before touching
switch off the illuminator and allow to cool
for a minimum period of 10 minutes.
Do not stay in the vicinity of the device
when it is powered. Act on the device only
in the absence of a power supply.
Make sure that all parts are fastened down
firmly and safely.
The unit is switched on by connecting the power
supply.
To switch off the unit disconnect the power.
MNVCUPKHXL_2222_EN