Videotec ULISSE RADICAL Manuel D'instructions page 20

7.9 Connection of the LED
illuminators
Insert the power supply cables through the cable
glands by at least 25 cm. Tighten the cable glands.
25cm
Fig. 27
To ensure the safety and the correct
operation of the unit do not leave a surplus
of the cable externally.
Fig. 28
Connect the cables as shown in figure.
The left illuminator (MASTER) must be connected to
connector J15. The right illuminator (SLAVE) must be
connected to connector J9.
Black
White
Red
Green
Fig. 29
18
25cm
J9 J9
J15 J15
7.10 LED illuminator activation
and adjustment instructions
Once the adjustment is done the illuminator on
the left (MASTER) synchronizes and controls the
illuminator on the right (SLAVE).
The dusk switch detects the room light and controls
the activation and deactivation of the illuminators
when brightness reaches the level set by the user.
When the LED illuminators are active the camera
goes to night mode with the special ONVIF control.
7.10.1 Description of the LED
illuminator
Do not remove the transparent screw of the
twilight sensor in order not to affect the
security and operation of the illuminator.
• Twilight sensor: Detects the light level.
• Cable: Power supply and control.
• Switch-on threshold regulator: The
potentiometer allows adjusting the sensitivity
threshold to switch on the illuminator.
• Infrared power control: The potentiometer allows
adjusting the power of the illuminator.
Twilight sensor
Switch-on threshold
regulator
Fig. 30
Cable
Infrared power
control
MNVCUPKHXL_2222_EN