Videotec ULISSE RADICAL Manuel D'instructions page 18

7.5 Connection of the Ethernet
cable
Connect the ethernet cable to the relative connector
(Ethernet, 7.3 Connector board description, page 13).
Fig. 20
7.6 Fixing the upper body
Fix the upper body (01) to the base (02) using the
fixing screws (03) equipped with gaskets (04). Make
sure the base seal is present and in good condition
(05).
Pay attention to the fixing. Tightening
torque: 4Nm.
01
05
Fig. 21
There is one anchoring position between
the base and upper body. Align side
projections to obtain the correct
positioning.
16
Ethernet
02
04
7.7 Counterweights installation
Fasten the counterweights to the housing using the
screws and washers supplied.
Fig. 22
Put some thread-locker into the holes for
screws (Loctite 243®).
Pay attention to the fixing. Tightening
torque: 16Nm.
03
MNVCUPKHXL_2222_EN