Battery Maintenance; Machine Storage; Repacking The Machine; Transporting The Machine - Nilfisk PBU 56384167 Manuel D'utilisation

Battery Maintenance

The battery supplied with this machine is a sealed,
absorbed glass mat (AGM), maintenance free type. It
never needs servicing. When battery replacement is
necessary (Part #: 56384309).
1. Push machine to level surface.
2. Turn off LP cylinder and remove it.
3. Disconnect the BLACK negative battery cable first.
Disconnect the RED positive battery cable last.
4. Loosen battery-retaining strap.
5. Lift out old battery and replace with new battery.
6. Secure battery with battery-retaining strap.
7. Connect the RED positive battery cable first.
Connect the BLACK negative battery cable last.
Note: Dispose of old battery in the proper manner.
Most auto parts stores accept used batteries for
recycling.
PROPOSITION 65 WARNING
l Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm.
l Batteries also contain other chemicals known to
the State of California to cause cancer.
l Wash hands after handling.

Machine Storage

Only authorized, trained personnel should have access
to propane cylinders and machines.
1. Remove propane fuel cylinder when not in use and
store it outside in a storage cage in accordance
with NFPA Handbook 58 CAN/CGAB149.2. Do not
release or bleed propane inside the building. Please
consult your local Fire Marshal to ensure that you are
in compliance with local fire codes.
2. Store machine away from objects that may fall and
damage it.
3. Never store machine or fuel cylinders near an
open flame or heat-producing device.
4. Make sure machine is cleaned properly before
storing.
5. Never store machine with cylinders installed, or store
spare cylinders in an enclosed van or trailer.
6. Store machine in a dry location, temperature not to
exceed 120°F (50°C).

Repacking the Machine

Refer to Unpacking and repack the machine using
original packing materials and container. Store
machine in a dry location, temperature not to exceed
120°F (50°C).

Transporting the Machine

When transporting a propane powered floor machine
with the fuel cylinder installed, the cylinder should be
securely fastened with the service valve closed and
the machine should be secured in the vehicle. Any
propane fuel cylinders not installed should be securely
fastened to avoid movement and damage. Never
store machine with cylinder installed or store spare
cylinders in an enclosed van or trailer. It is a good
practice to check propane cylinders for overfilling
before transporting them. If overfilled, correct before
loading them in the vehicle by venting the excess
propane outside in a safe area using the bleeder valve.
A23