HumanTechnik Signolux Mode D'emploi page 14

Setup as a baby alarm
The »Acoustic universal transmitter«
can register a crying child and then
transmit an according signal to all
assigned »signolux«-receivers within
reach.
To do so, it is neccessary to aquire
the baby-microphone cable (Item no.
A-2691-0, available as accessory).
The included microphone cannot be
used for this purpose!
Mount the baby microphone in the
proximity of the child's bed. A self-
adhesive velcro band is supplied for
this purpose.
For reasons of health and safety:
Make absolutely sure that the child
cannot reach the microphone and /
or the attached cable!
Plug the baby microphone cable into
socket #2 of the underside of the
»Acoustic universal transmitter«.
For a reliable transmission, the sensi-
tivity control should be set in such a
way that the transmitter reacts secu-
rely to the child's crying.
Method:
- Set the sensitivity control #2 to the
most sensitive (extreme right, turn
clockwise).
- Should the transmitter react to neg-
legible noises (e.g. snoring, sighing,
sniffles), please decrease the sen-
sitivity in small steps (turn counter-
clockwise) until the transmitter stops
to react to irrelevant sounds.
English 14
The exact setting needs to be found
by multiple changes to the sensitivity,
in order to match your specific requi-
rements.
The baby alarm function can be con-
veniently switched on and off with the
baby alarm switch (Figure 1).
Please note:
Using the baby microphone requi-
res a higher amount of energy from
the transmitter. This causes the bat-
teries to suffer a shorter life span,
the stand-by time reduces down
to approx. 100 days per battery
change.
Therefore we emphasize on using the
»signolux« power supply (Item no.
A-2690-0, available as accessory) if
the »Acoustic universal transmitter«
is used as a baby alarm.