Grizzly BRM 4613-20 A E-Start Traduction De La Notice D'utilisation Originale page 85

Setting the Cutting Height
The equipment has 10 positions for set-
ting the cutting heigh (25-75 mm):
1. Pull the lever (18) outwards and
push it to the desired position .
2. Push the lever back in.
The correct cutting height is around
25 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Select a greater cutting height for
the first cut of the season.
Operation
Observe noise control and local
regulations.
Starting and Stopping the
Engine
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
Regularly check petrol and oil level
(see „Initial Operation") and refill in
due time.
Start the motor (electric
start):
1. For a cold start, set the choke
lever (26) to the
For a warm start, leave the cho-
ke lever (26) in the
The rechargeable battery (25) of the
electric motor (32) recharges while you
are mowing. If this is not enough because
you have repeatedly mown small areas,
please start with the starter handle
(
position.
position.
2. Pull the safety loop (3) towards
the grip handle (1) and hold it.
3. Press the start button (27).
The motor starts.
22):
Start the engine (manually):
1. For a cold start, set the choke
lever (26) to the
For a warm start, leave the cho-
ke lever (26) in the
2. Pull the safety catch (
wards the handle bar and hold it.
3. Pull the starter cord (
4. When the engine starts, allow
the starter handle to slowly slide
back into the starter cable guide
( 21).
Stopping the engine:
5. Release the safety loop (
The motor switches off and the
knife is braked.
If the battery does not charge up
again during mowing after having
been discharged for a considera-
ble time, you can charge this up
using an external charger. For this,
the plug-in connector (31) has to
be detached and a corresponding
charger (not supplied) connected.
Regularly examine the knife
stopping device:
Release the safety loop (
The motor switches off and the
knife is braked. The knife must
stop within 7 seconds.
GB
position.
position.
3) to-
22).
3).
3).
85