Propeller Replacement - TOHATSU MFS 25C Manuel De L'utilisateur

72
INSPECTION AND MAINTENANCE
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
ENOW00095-0
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly to
prevent entry of water into lower unit.
10
ENOW00928-0
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
ENOF01132-0
CAUTION
ENOF01133-0
CAUTION
fire prevention and environment protection
regulations.
ENON00032-0
Note
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 360 mL (11.8
fl.Oz).
ENOM00086-A

Propeller replacement

ENOW00084-0
WARNING
Do not begin propeller removal and
installation procedure with spark plug
c a p s a t t a c h e d , s h i f t i n f o r w a rd o r
reverse, main switch at other than
"OFF", engine stop switch lock attached
to the switch, and starter key attached,
or engine could accidentally start lead-
ing to serious personal injury. Discon-
nect battery cable if possible.
The propeller edge is thin and sharp.
Wear the groves during replacement to
protect your hands.
ENOW00086-0
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
A worn-out or bent propeller will lower the