Operation In Dehumidification Mode "Dry; Setting The Clock - emmeti EGWW - 0712 Manuel D'installation Et D'utilisation

3. USE OF FAN

3.7 Operation in dehumidification mode "Dry"

 Press the MODE key to select the
- +
 Use the keys to set the desired room temperature (16÷30 °C).
The temperature can be set degree by degree.
3 The fan speed and set to MIN.
4 Premendo il pulsante
desiderata.
Te
- valvola aperta
Ts+2
- ventilatore in funzione alla veloctà
MIN
- valvola chiusa
- il ventilatore resta fermo per 5 minuti,
poi riparte alla velocità MIN per 1
minuto
- temperatura interna visualizzata a
display fissa Ts-2
Ts-2
Note:
Te: Environment temperature
Ts: Set temperature
The unit is a hydronic terminal and its operating
mode depends on the chiller or boiler.
Attention!
The signal is automatically sent to the fan; the display will briefly show the
symbol .
It's essential to include a motorized valve in the
water circuit in order to prevent the formation of
condensation.
Note: The settings for temperature, fan speed and Swing are kept in
memory for each mode of operation.
. operating mode
selezionare la posizione dei deflettori
- valvola aperta
- ventilatore in funzione alla velocità
MIN
- After 1 minute valve closed and the fan
is stopped
- il ventilatore resta fermo per 5 minuti, poi
riparte alla velocità MIN per 1 minuto.

3.8 Setting the clock

 Press the CLOCK key once; on the display will flash.
–
2 Within 5 seconds, press the
3 While the icon is flashing,
symbol will stop flashing and the desired time will be set.
4 If the CLOCK button is not pressed again after setting the time
while ,is flashing, the set time will not be stored.
GB GB
+
and keys to set the current time.
press the CLOCK button again, the
47