Publicité
Les langues disponibles
Les langues disponibles
O R IGINA L INST R U CT ION
6. SERVICING THE TOOL
6.1 MAINTENANCE FREQUENCY
Item
General tool inspection
Check mandrel for wear or damage
Check and clean nose jaws
Check and degrease OP-Ring on screw
Remove, inspect and clean tail jaws
Full dismantle, replace worn components and
grease drive assembly
*Contact authorized service centre to complete
6.2 CLEANING
ALWAYS wear approved eye protection at all times when cleaning equipment
6.2.1
TOOL EXTERIOR
Keep the brushless motor Exhaust Vent openings free from dust and dirt. If necessary, use a soft, moist
cloth to remove dust and dirt from the exhaust vents.
WARNING: Wear approved eye protection and approved dust mask when performing this
procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse
any part of the tool into a liquid.
6.2.2
APPEARANCE CHECK
Inspect the tool for the following:
•
Damage to the Handles, barrel and nose jaws
•
Loose components and screws
•
Any oil spots on the housings
•
Peeling of the over mold (Rubber grip)
•
Blockage of Exhaust Vents
•
Illegible or missing warning labels
6.3 CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning.
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush.
DO NOT use water or any cleaning solutions
20
Frequency
Daily
Daily
Daily or 10,000 installations
Weekly
Weekly
500,000 installations or annually*
Publicité
