Publicité
Les langues disponibles
Les langues disponibles
O R IGINA L INST R U CT ION
•
Select Reload mode and hold trigger for >1second until tool actuates and work light starts to fl ash at
1 second intervals
•
Insert the previously assembled mandrel, mandrel follower spring and fasteners into the nose jaws until
the mandrel fully backs onto mandrel stop. There should be a small quantity of fasteners protruding
from the nose jaws.
•
Supporting the nose jaws, press and hold the trigger for >1s and the tool will actuate to the home
position. Ensure the mandrel and rivets do not move with the tool
•
Close nose jaws and ensure 1 rivet is showing. If incorrect position, refer to Mandrel section (5.4) to
adjust.
5.3 TAIL JAWS
5.3.1
REMOVING THE CARTRIDGE
•
Ensure the tool is in home position and mandrel removed from tool.
•
Slide forwards the cartridge latch, rotate the cartridge cover upwards to expose the tail jaw cartridge
•
Lift cartridge handle and slide cartridge upwards away from the tool
•
Fitting the cartridge is the reverse of this procedure
CARTRIDGE
HANDLE
CARTRIDGE
LATCH
5.3.2
REPLACING THE TAIL JAWS
•
Ensure tail jaw cartridge removed from tool
•
Carefully clamp cartridge body vertically so end cap is facing upwards
•
With a 30mm spanner, unscrew end cap from cartridge body
•
Remove cartridge body from clamp remove the spring and jaw turret from body.
•
The jaws sit in the jaw turret, replace as necessary.
•
Assembly is the reverse of this procedure. Ensure the jaws seat correctly when assembling.
18
CARTRIDGE
1.5mm - 3mm
(1/16" - 1/8")
CARTRIDGE
COVER
Publicité
