General Safety Information - Superwinch T2000 Mode D'emploi

G E N E R A L S A F E T Y
I N F O R M A T I O N
( C O N T. )
17. NEVER RELEASE FREESPOOL
CLUTCH WHEN THERE IS A LOAD
ON THE WINCH.
18. NEVER WORK ON OR AROUND
THE WINCH DRUM WHEN
WINCH IS UNDER LOAD.
19. DO NOT OPERATE WINCH
WHEN UNDER THE INFLUENCE
OF DRUGS, ALCOHOL OR
MEDICATION.
20. ALWAYS DISCONNECT WINCH
POWER LEADS TO BATTERY
BEFORE WORKING IN OR
AROUND THE WINCH DRUM so
that the winch cannot be turned
on accidentally.
21. When moving a load, slowly
take up the wire rope slack until
it becomes taut. Stop, recheck all
winching connections. Be sure
the hook is properly seated. If a
nylon sling is used, check the
attachment to the load.
22. When using your winch to move
a load, place the vehicle trans-
mission in neutral, set vehicle
brake, and chock all wheels.
6
23. DO NOT USE THE WINCH TO
HOLD LOADS IN PLACE.
Use other means of
securing loads such
as tie down straps.
24. USE ONLY FACTORY APPROVED
SWITCHES, REMOTE CONTROLS
AND ACCESSORIES. Use of non-
factory approved components
may cause injury or property
damage and could void your
warranty.
25. DO NOT MACHINE OR WELD
ANY PART OF THE WINCH. Such
alterations may weaken the
structural integrity of the winch
and could void your warranty.
26. DO NOT CONNECT WINCH TO
EITHER 110V AC HOUSE CUR-
RENT OR 220V MAINS AS WINCH
BURNOUT OR FATAL SHOCK
MAY OCCUR.
27. Never allow shock loads to be
applied to winch or wire rope.
28. Use caution when pulling or
lowering a load up and down a
ramp or incline. Keep people,
pets and property clear of the
path of the load.
I N S T A L L A T I O N
Correct installation of your winch is
required for proper operation.
This winch MUST
WARNING
!
be mounted
with the wire rope in the under-
wind direction. Improper mounting
could damage your winch and void
your warranty.
Step (1)
Install mounting kit or structural
support for winch.
2
3
4
2 Red
+ BAT
4 Black
3 Blue
Step (2)
Mount the winch to the mounting
kit base plate or to the mount that
you have designed. Typical mount is
to a flat surface capable of han-
dling the loads.
The M8 x 1.25 x 30mm mounting
bolts supplied are the correct length
for use with a 1/4" (6.3mm) thick
mounting plate.
Do not substi-
WARNING
!
tute any
strength grade weaker than ISO
grade 4.6
Step (3)
Check to ensure that the vehicle
ground and positive leads from the
battery are disconnected before
performing any electrical work.
Batteries contain
DANGER
!
gasses which are
flammable and explosive. Wear eye
protection during installation and
remove all metal jewelry. Do not
lean over battery while making
connections.
3 To Motor Blue
2 red to battery (+)
1 To Motor Yellow
3 To Motor Blue
2 red to battery (+)
1
1 To Motor Yellow 4 black to battery (–)
4 black to battery (–)
1 Yellow
Figure 7
7