Master/Slave-Operation; Blackout-Socket - Futurelight CENTERPIECE-1200 Mode D'emploi

A safety rope which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the side of the FUTURELIGHT CENTERPIECE-1200 you can find an XLR-jack (DMX Out) and an XLR-
plug (DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
001 d
n1n n
n2n
n3n
Set the desired Master-mode for the master-device. Set the respective Slave-mode for the slave-devices.
Please note: The function N3N is only meant for service-purposes. Please do only use this function if you
want to set the unit shortly into standby mode. If the unit remains on N3N, it cannot be controlled by DMX
anymore!

Blackout-socket

If you wish to lock the light output - e.g. via an optional footswitch (Blackout-mode), connect your footswitch
via a mono-jack plug to the Blackout-socket.
DANGER TO LIFE!
Control Board:
DMX-mode
Master-mode:
Sound-control
n
Master-mode:
Slow
n
Master-mode:
Standby
Occupation mono 1/4" jack-plug:
Tip
In Phase (+)
24/60
s1s s
19 f
13 f
Sleeve
Ground
Slave-mode:
Slave 1
Program-mode:
19 DMX-channels
Program-mode:
13 DMX-channels
51832625_V_1_1.DOC