Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Lighting effects must not be connected to dimming-packs.
Before taking into operation for the first time, the installation has to be approved by an expert!
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the DJ-SCAN 575 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In),
which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
001
n1n
n2n
n3n
Set the desired Master-mode for the master-device. Set the respective Slave-mode for all slave-devices.
Please note: The function N3N is only meant for service-purposes. Please do only use this function if you
want to set the unit shortly into standby mode. If the unit remains on N3N, it cannot be controlled by DMX
anymore!
Pan Reverse
With this function you can reverse the Pan-movement.
2 P
1 1
P
Tilt Reverse
With this function you can reverse the Tilt-movement.
1 E
2
E
Reverse display
1 L
With this function you can rotate the display by 180°.
2L
DANGER TO LIFE!
Control Board:
D
s1s
DMX-mode
Master-mode:
s2s
N N
Sound-control
N N
Master-mode:
s3s
Slow
Master-mode:
s4s
N N
Standby
s
Slave-mode:
1 1
Slave 1
s
Slave-mode:
2
Slave 2
s
Slave-mode:
1
Slave 3
s
Slave-mode:
2
Slave 4
1
2
28/64
P
Pan mode:
-
Positiv
P
Pan mode:
-
Reverse
E
Tilt mode
-
:
Positiv
E
Tilt mode:
-
Reverse
L
LED positiv:
-
Displa
y
L
LED negativ:
-
Displa
y
DJ_SCAN_575_V_1_0
Publicité
Table des Matières
